User's Guide

TD851W 150Mbps Wireless N ADSL2+ Modem Router User Guide
• VPI: Identifies the virtual path between endpoints in an ATM network. The valid range is
from 0 to 255. Please input the value provided by your ISP.
• VCI: Identifies the virtual channel endpoints in an ATM network. The valid range is from
32 to 65535 (1 to 31 is reserved for well-known protocols). Please input the value
provided by your ISP.
• Encapsulation: Specifies the type of Multiplexing, either LLC or VC-Mux. Please note
that VC-Mux is not available for IPoA channel mode.
• Channel Mode: There are six channel modes, 1483 Bridged, 1483 MER, PPPoE,
PPPoA, 1483 Routed and IPoA. Please choose the mode that you want to use.
• Enable NAPT: Choose to enable the NAPT function or not.
• Enable IGMP: Choose to enable the IGMP function or not.
¾ PPP Settings: These parameters are only available for PPPoE and PPPoA channel mode.
• User Name: Enter your user name for your PPPoE/PPPoA connection.
• Password: Enter your password for your PPPoE/PPPoA connection.
• Type: Select Continuous, Connect on Demand or Manually for the network
connection. Continuous means the Internet connection will always keep on. Connect
on demand is dependent on the traffic. If it’s idle (there is no traffic) for a pre-specified
period of time), the connection will tear down automatically. And once there is traffic send
or receive, the connection will be automatically on. Manually means you have to
manually connect or disconnect your Internet by clicking the Connect or Disconnect
button at the bottom of this page.
• Idle Time (min): Specifies the idle time for Connect on Demand type.
¾ WAN IP Settings: These parameters are only available for 1483 MER and 1483 Routed
channel mode. Please note that for1483 Routed mode, DHCP is not available.
• Type: Selects to use Fixed IP or DHCP. If Fixed IP is selected, then you have to fill the
following parameters, including Local IP Address, Remote IP Address, and Netmask.
Otherwise, these parameters will not be available.
• Local IP Address: The IP address of the router on the PVC channel.
• Remote IP Address: The gateway’s IP address of the router on the PVC channel.
• Netmask: The subnet mask of the router on the PVC channel.
¾ Connect/Disconnect: When there is a VC using PPPoE/PPPoA channel and Manually type,
you need to click this button to connect/disconnect the network.
20