User manual

6F8A0917
- 95 -
Checking the count rate and pulse width
How to check the count rate setting is shown below.
To check other setting values, select the following function numbers:
Pulse width mode
H2: PLS MODE
Pulse width H3: PLS WIDTH
Switch operation Display example Description
H1: COUNT RATE
1.00000 m3
Select H1: COUNT RATE from the setting item selection
menu.
The currently set count rate appears.
H
1: COUNT RATE
Returns to the menu of setting item selection.
Changing the count rate
The following is an example to change the count rate from 0.01m
3
to 200 l (liter).
Switch operation Display example Description
H1: COUNT RATE
1.00000 m3
Select H1: COUNT RATE from the setting item selection
menu.
The currently set count rate appears.
H1: COUNT RATE
1.00000 m
3
The cursor appears.
Press
further to move the cursor to the digit of unit.
H1: COUNT RATE
1000.00 l
↓
200.000 l
Change the unit to l.
Then press
to move the cursor to the desired digit to change
and change the number there. Repeat this operation until 200 l
appears on the display.
H1: COUNT RATE
200.000 l
The display blinks and the set value is displayed for
confirmation.
Press
MENU/ENT
again to write the data. Then the cursor
disappears and the display returns to the condition that the set
value is displayed.
H
1: COUNT RATE
Returns to the menu of setting item selection.
Note: The indicting units for count rate are displayed cyclically as shown below.
m
3
ml
l
gal bbl
pt qt