User Guide

3. APPEARANCE
3. 2 LED and Feed Button
3-2
SPAA-207-R1
Error Status Table
Green LED Blinking (Slow)
Problem What to Do Where to Go
Receipt paper is low
There are about 4 ½ meters, ± 3 meters,
(15 feet, ± 10 feet) of paper left. Change
the paper soon to avoid running out of
paper part way through a transaction.
See “Loading the
Receipt Roll” in
chapter 5.3.
Green LED Blinking (Fast)
Problem What to Do Where to Go
Receipt paper is out Change the paper now. Do not run a
transaction without paper as the data
may be lost.
See “Loading the
Receipt Roll” in
chapter 5.3.
Receipt cover is open Close the cover. The printer will not
operate with the cover open.
Knife failure Open the receipt cover and check the
knife. Clear any jammed paper you can
see. Tear off any excess paper against
the tear-off blade.
NOTE: If other LED status except for the above occurs, turn the power off, and then on. If this
does not restore the LED, contact your nearest TOSHIBA TEC representative for assistance .