Instruction Manual
E6581738
- 20 -
4. Vendor Spec. Profile
Cyclic command transmission (the value of the parameter c001 - c006) and
monitoring (the value of the parameter
c021 - c026) are possible for PDP003Z by
the original profile
Select the ”Telegram 100”, ”Telegram 101” or ”Telegram 102” as the profile on the
configuration. Refer to the PLC configurator documents.
c001 - c006 setup value c021 - c026 setup value
0: No action
1:
fa06 (Communication command 1)
2:
fa23 (Communication command 2)
3:
fa07 (Fequency command, 0.01Hz)
5:
fa50 (Terminal output data)
6:
fa51 (FM analog output)
8:
f601 (Stall prevention level, %)
13:
acc (Acceleration time 1, 0.1s)*
14:
dec (Deceleration time 1, 0.1s) *
15:
ul (Upper limit,0.01Hz)
16:
vb (Torque boost value 1,0.1%)
17:
vlv (Base frequency voltage 1, 0.1V)
0: No action
1:
fd01 (Status information 1)
2:
fd00 (Output frequency, 0.01Hz)
3:
fd03 (Output current, 0.01%)
4:
fd05 (Output voltage, 0.01%)
5:
fc91 (Alarm information)
6:
fd22 (PID feedback value, 0.01Hz)
7:
fd06 (Input terminal board status)
8:
fd07 (Output terminal status)
9:
fe36 (VIB input, 0.01%)
10:
fe35 (VIA input, 0.01%)
11:
fe37 (VIC input, 0.01%)
12:
fd04 (Input voltage (DC detection), 0.01%)
13: fd16 (Estimated speed (real-time value), 0.01Hz)
14: fd18 (Torque, 0.01%)
19:
f880 (Free notes)
20:
fd29 (Input power, 0.01kW)
21:
fd30 (Output power, 0.01kW)
22:
fe14 (Cumulative operation time, hour)
23:
fe40 (FM terminal output monitor, 0.01%)
25:
fd20 (Torque current, 0.01%)
26:
fd23 (Motor overload factor, 0.01%)
27:
fd24 (Drive overload factor, 0.01%)
28:
fd25 (PBR overload factor, %)
29:
fd26 (Motor load factor, %)
30:
fd27 (Drive load factor, %)
31:
fe56 (Pulse train input, pps)
32:
fe70 (Drive rated current, 0.1A)
33:
fe76 (Input Watt-hour, 0.1kWh 10
f749
) **
34:
fe77 (Output Watt-hour, 0.1kWh 10
f749
) **
35:
fd83 (IGBT temperature, degree C)
* The unit of acc, dec is according to the parameter f519.
** The unit of
fe76, fe77 is according to the parameter f749.