High Definition LED Television Manual

Using the TV’s features

Adjusting the audio

When you use ColorStream

HD or Video, switch the AV input

mode appropriately.

Selecting the optical audio output format

You can select the optical audio output format when you connect a

Dolby

Digital decoder or other digital audio systems to the TV’s

Optical Audio Out terminal (see “Connecting a digital audio

system” on page 34).

To select the optical audio output format:

1 Press the MENU button and open the Sound menu.

2 Highlight Audio Setup, and then press the ENTER button.

3 In the Digital Output Format field, select either Dolby

Digital or PCM, depending on your device.

4 To save the new settings, highlight Done, and then press the

ENTER button.

To reset the settings to the factory defaults, highlight Reset,

and then press the ENTER button.

Using the Dolby

Digital Dynamic Range Control feature

You can further compress Dolby Digital dynamic range, allowing

you to switch from digital to analog broadcasts at the same dynamic

range.

To use the Dolby Digital Dynamic Range Control:

1 Press the MENU button and open the Sound menu.

2 Highlight Audio Setup, and then press the ENTER button.

3 In the Dolby Digital Dynamic Range Control field, select

either Compressed or Standard. When Standard is selected,

the audio outputs with minimal compression.

4 To save the new settings, highlight Done, and then press the

ENTER button.

To reset the settings to the factory defaults, highlight Reset,

and then press the ENTER button.

❖ This feature is available when the TV is tuned to a digital RF

channel with the Dolby Digital signal.

❖ The Dolby Digital Dynamic Range Control will function in

relation to Optical Output Format (PCM mode).

NOTE