High Definition LED Television Manual

Setting up your TV

Setting channel skip

To prevent a channel from being viewed, you can set it to be

skipped.

1 From the Setup menu, highlight Installation, and then press the

ENTER button.

2 Press the ( / arrow) buttons to select Channel Options, and

then press the ENTER button.

The list of channels appears.

(Sample Illustration) List of channels

3 Press the ( / arrow) buttons to select a channel position to

be skipped, and then press the ENTER button.

A check will appear in the box. To remove the check, press the

ENTER button again.

To add a channel to the channel memory:

❖ Highlight the checked box next to the channel number you

wish to add, and then press the ENTER button to remove the

check.

You can also block specific channels so that they cannot be tuned

until you unlock them. For information, see “Locking channels” on

page 98

To manually add digital sub-channels on a physical channel:

❖ Use the Channel Numbers and the (Dash 100) on the remote

control to enter the channel number (for example, 56–1).

If the channel is found, the number will be added to the list and

the box will be unchecked. If the channel is not found, a

message appears.

NOTE