B-SX5T Series Manual

7. SUPPLY SPECIFICATIONS ENGLISH VERSION EO1-33059
7.1 Media
E7- 5
(7) Printing on Bump (Chip/Antenna) Area
Embedding an RFID tag in labels creates bumps on the label surface, causing incomplete printing.
Uneven printing or incomplete printing can occur easily, especially within 5 mm back and forth, and right and
left sides of the RFID-tag embedded area, as shown in the figure below.
(8) Ambient Temperature
As low temperature deteriorates wireless performance, writing data on an RFID tag may fail under such
conditions.
(9) Head-up Reverse Feed
When an RFID label is used, a reverse feed may be required before an issue depending on the location of an
RFID tag in the label.
A printer without the ribbon saving module may not be able to perform a reverse feed properly because the print
head may be caught by an edge of the label. For this reason, the ribbon saving module must be installed in the
printer when media, which requires a reverse feed before an issue, is used.
(10) Strip Issue
Stripping performance in strip issue mode depends on the type of glue, tag, and backing paper. For some RFID
supplies used, a strip issue may not be performed properly.
(11) Caution for Minimum Label Pitch Length
When media, of which label pitch length is short, is used, data may be written on an RFID tag next to the target
RFID tag.
As the location, where data is to be written, differs among RFID tag types, a check must be performed to make
sure that the data is written on the target RFID tags. The B-SX RFID Analyze Tool can be used for this purpose.
For details, please contact the nearest TOSHIBA TEC service representative.
(12) Defective RFID Supply
RFID supplies may include defective RFID tags at the time of shipment from the maker. The defect rate differs
depending on tag types, method of converting to supplies, etc.
The RFID supply maker should provide a way to distinguish defective tags by printing a mark on them or any
other methods.
Or, defective tags should be rejected in the production process.
How to distinguish a defective tag from good one must be notified to end users.
Poor printing may occur in
this area due to a bump.
5 mm
5 mm
Media feed
direction
Poor printing may occur in
this area due to a bump.
RFID-tag
Embedded
area
N
OTE: The degree of poor printing quality differs depending on height of a chip/antenna used.