Microcomputer Product Guide

60
Programming tools / Accessories
Flash adapter
Enables Toshiba's Flash microcontrollers to be programmed on a
stand-alone basis.
Can be used with Toshiba's Flash microcontrollers of any Family
or Series in the same package.
(*The user is required to connect write signals and mount
oscillators as appropriate to each device.)
Comes with "Flash Programmer"-programming control software
controllable on a PC.
Ensures ease of operation through the GUI-based control
software.
Allows programmed data to be compared on a byte basis.
Yokogawa Digital Computer's programmer (NET IMPRESS) can
be used as a host system.
The Flash adapter is provided for each package type of Toshiba’s microcontrollers with on-chip Flash memory.
Connecting the Flash adapter with a host system allows you to program, erase, and verify on-chip Flash memory.
Although this tool can be used both for product development and mass production, some limitations apply when it is
used for mass production. For details, visit Toshiba’s Microcomputer website. The website provides various support
information for the Flash adapter including its control software upgrades to flexibly support newly developed devices.
OTP programming adapter
This is an adapter for converting the pinout of an OTP
microcontroller to that of a general-purpose EPROM. The OTP
programming adapter enables an OTP microcontroller to be
programmed and verified by an off-the-shelf EPROM
programmer. This adapter is provided for each OTP
microcontroller type.
Socket for
mounting
MCU with
on-chip
Flash memory
NET IMPRESS
connector
RS-232C
D-SUB
9-pin male
Power
supply
OTP microcontroller
OTP programming
adapter
EPROM
programming socket
Programming tools
MCU probe
The MCU probe is used to connect a target system and an emulation pod,
and is provided for each package type. The MCU probe used for a flat
package comes with a QFP adapter and a pin protector.
* The RTE870/C Light system requires a probe specifically tailored to the Light
system. For details, see page 8.
Pin protector
The pin protector is a protective socket for an MCU probe and a QFP adapter. Be
sure to use the pin protector to prevent MCU probe's joint from losing its spring
after repeated attachments and detachments.
* We recommend replacing the pin protector after 100 attach-detach cycles.
QFP adapter
The QFP adapter is used to connect an emulation pod or an emulation
module to a target system designed for a QFP-type microcontroller. It is
soldered onto the foot pattern on the target system board.
* Once soldered, the QFP adapter cannot be reused.
* The pin protector and QFP adapter of the same specifications are also available
from Tokyo Eletech Corporation.
MCU mounting adapter
The MCU mounting adapter is used together with the QFP adapter to mount a
microcontroller on the target system.
Accessories
For part numbers and tool combinations,
see "PART NUMBER LIST" or Development System website.
MCU probe
Pin protector
QFP adapter
MCU mounting adapter
QFP adapter