Projector Accessories User Manual

1918
Preparations
■ Operating the remote
control
Turn on the ON/OFF switch of the
remote control.
Point toward the projector’s
infrared remote sensor, and press a
button on the remote control.
• Operating the projector from the front
Approx. 15°
Approx. 5m
■ Loading dry-cell batteries
into the remote control
q Remove the battery cover.
w Insert the dry-cell batteries.
Be sure to align the plus and minus
ends of the batteries properly.
Tw o batteries (LR03, SIZE AAA) are
used.
e Replace the battery cover.
Dry-cell batteries
• Before using the batteries, be sure to observe the Safety Precautions described in
previous pages.
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries with
new ones.
The remote control
•Turn off the ON/OFF switch of the remote control when not in use or to store in baggage.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
Preparing and using the remote controlNames of the terminals on the rear panel
(4) (6)(3)(2) (5)
(7) (9) (10)
(1)
(8)
Name : Main Function
(1) CONTROL terminal : When operating the projector via a computer, connect
this to the controlling computer’s RS-232C port.
p.52
(2) MONITOR terminal : Connect to a computer display, etc.
(3) AUDIO IN terminal : Input audio signals from a computer, or from video
equipment with a component video signal output
terminal.
(4) COMPUTER 1 IN terminal : Input RGB signal from a computer or other source, or a
component video signal (Y/P
B/PR) from video
equipment.
(5) AUDIO (L/R) terminal : Input audio signals from video equipment.
(6) S-VIDEO terminal : Input S video signals from video equipment.
(7) AUDIO OUT terminal : Outputs audio signals.
(8) COMPUTER 2 IN terminal : Input analog RGB signal from a computer or other
source, or a component video signal (Y/P
B/PR) from
video equipment.
(9) AUDIO (L/R) terminal : Input audio signals from video equipment.
(
10 ) VIDEO terminal : Input video signals from video equipment.
When operating the remote control
from behind the projector, the laser
light is reflected on the projecting
surface and may travel a shorter
distance to reach the projector
depending on the shape and material
of the projecting surface.