Operation Manual

50
CAUTION
• If you have been using the projector, the lamp will be very hot, and may cause burn
injuries.
Wait for the lamp to cool (for longer than 1 hour) before replacing it.
• If the lamp should break, please handle with care to avoid injury due to broken pieces
and contact your dealer for repair service.
1
Unplug power cord.
2
Wait until lamp is suffi ciently cooled.
Wait for at least 1 hour.
3
Keep the projector stationary.
Do not move the projector while replacing the
lamp.
4
Remove the lamp cover.
Loosen the two screws and raise the lamp
cover.
If necessary, use a screwdriver or other small
tool to remove the cover. Use care to avoid
damaging your fi ngers.
5
Remove the lamp.
Loosen the three lamp locking screws and pull
up the handle to release the lamp. Remove the
lamp.
Lamp replacement (Continued)