Laptop User Manual

Getting Started

Adding memory (optional)

Avoid touching the connector on the memory module or on the

computer. Grease or dust on the connector may cause memory

access problems.

9 Carefully remove the new memory module from its antistatic

packaging, without touching its connector.

10 Locate an empty memory module slot on the underside of the

computer.

If no memory slot is available, you must remove a module by

performing steps 2-3 of “Removing a memory module” on page 55.

For this model, Slot A is the slot on the right-hand side of the

memory compartment, when looking from the front of the computer.

Slot B is the slot on the left-hand side. If only one memory module is

to be installed, it must be installed in Slot A.

11 Pick up the memory module by its sides, avoiding any contact

with its connector. Position the module toward the socket,

aligning the connector’s notch with the matching key in the

socket.

(Sample Illustration) Aligning the memory module with the socket

NOTE

latch

key

notch

connector