User Guide

User's Manual Setup and Password Security 7-17
Version
1
Last Saved on 27/01/00 18:20
Satellite Pro 4200/4300 User's Manual – 4200_UK.doc – ENGLISH – Printed on 27/01/00 as
IM_420UK
6.
a.) If character strings match, the password is registered and the
display changes to:
SUPERVISOR PASSWORD = Registered
USER PASSWORD MODE = Unable to run SETUP
Do you want to change the setting <Y/N>?
If you do not want to provide user access to the TSETUP program,
press
N
to return to the DOS prompt.
To provide user access to TSETUP, press
Y
and continue with the
procedures in the section
Enabling TSETUP
in this chapter.
b.) If the character strings do not match, the following message
appears:
Password verify error!
Do you want to retry <Y/N>?
Press
Y
to return to step 3. Press
N
to return to the DOS prompt.
User password
To enter a user password, execute TSETUP, then:
1.
Go to the
Password
item and press the
Space
or
BkSp
key to
display the following prompt:
Password =
2.
Enter a password of up to 10 characters. The character string you
enter is displayed as a string of asterisks. For example, if you enter a
password consisting of four characters, the display is shown as:
Password = ****
If you press
Enter
before entering the password,
Not registered
will
appear on the display.
3.
Press
Enter
. The following message appears, allowing you to verify
the password.
Verify Password =
4.
If character strings match, the password is registered and the display
changes to:
Registered
If they do not match, the following message appears along with a beep
indicating you must repeat from step 2.
Entry Error!!