User Guide

Chapter3 Test Program for Field.
Satellite L10 Maintenance Manual (960-Q01) [CONFIDENTIAL] 3-33
3.8 Floppy Disk Test
CAUTION: Before running the floppy disk test, prepare a formatted work disk. Remove
the diagnostics disk and insert the work disk into the FDD. The contents of the floppy disk
will be erased.
To execute the Floppy Disk Test select 05 from the Diagnostic Test Menu, press Enter and
follow the directions on the screen. The Floppy Disk Test contains five subtests that test the
FDD. Move the highlight bar to the subtest you want to execute and press Enter.
The Test Parameter menu displays after selecting each subtest of the Floppy Disk Test.
Select the parameters to execute the test.
TEST PARAMETERS
Go To Test
Test Loop NO
Error Stop NO
Test Drive Number 1
Media Type 1.44MB
Test start track number 0
1. Go To Test
Move the highlight bar to Go To Test to start executing the test.
2. Test Loop
Select YES to set the test to run continuously until it is halted by the user. Select NO
to return to the Floppy Disk Test menu after the test is complete.
NOTE: If NO is selected for Test Loop on the Test Parameter menu, the Test
Status screen displays while the test is executing. When the test is complete the
Floppy Disk menu displays.
If YES is selected for Test Loop on the Test Parameter menu, the Test Status
screen displays, press Ctrl + break to return to the Floppy Disk menu.
3. Error Stop
Select YES to stop the test program when an error is found
Select NO to keep the test running even if an error is found.