Notebook Computer User's Guide

66
Getting Started
Installing additional memory (optional)
5.375 x 8.375 ver 3.1
If you use the computer for a long time, the memory modules
will become hot. If this happens, let the modules cool to room
temperature before you replace them.
Do not try to install a memory module under the following
conditions. You can damage the computer and the module.
1. The computer is turned on.
2. The computer was shut down using Standby mode.
3. Power to the DVD-ROM or multi-function drive has been
turned on.
Do not install or remove a memory module while the
DVD-ROM or multi-function drive power is on.
You need a standard Phillips no. 0 (zero) screwdriver and a
small flat-head screwdriver to install a memory module.
To avoid damaging the computer’s screws, use a standard
Phillips no. 0 (zero) screwdriver that is in good condition.
If you are adding memory after you have started to use the
computer, begin at step 1, otherwise skip to step 2.
1 Turn off the computer via the Start menu. See “Turn Off
or Shut down command” on page 103.
The operating system turns off the computer.