Owner manual

Optional Devices

Satellite 2430 Series 7-13

Satellite 2430 Series

Version

Last Saved on 04/04/2003 13:35

ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN

Connecting

1. Make sure the connectors are properly aligned and plug the i.LINK

(IEEE1394) cable into the computer.

2. Plug the other end of the cable into the device.

Note the following when you use i.LINK:

■ You may need to install drivers for your i.LINK devices.

■ Not all i.LINK devices have been tested. Therefore, compatibility with

all i.LINK devices cannot be guaranteed.

■ Use S100, S200 or S400 cables no longer than three meters.

■ Some devices might not support standby or automatic off functions.

■ Do not connect or disconnect an i.LINK device while it is using an

application or when the computer is automatically shutting it down to

save power. Data might be destroyed.

Disconnecting

1. Click the Eject or Remove Hardware icon on the Task Bar.

2. Point to i.LINK (IEEE1394) device and click.

3. Disconnect the cable from the computer then from the i.LINK device.

Refer also to the documentation that came with your i.LINK device.