User's Manual

5.375 x 8.375 ver 2.3

Alarm Equipment

If your home has specially wired alarm equipment connected to the telephone

line, ensure the installation of this equipment does not disable your alarm

equipment. If you have questions about what will disable alarm equipment,

consult your telephone company or a qualified installer.

Instructions for IC CS-03 Certified Equipment

1 NOTICE: The Industry Canada label identifies certified equipment.

This certification means that the equipment meets certain

telecommunications network protective, operational and safety

requirements as prescribed in the appropriate Terminal Equipment

Technical Requirements document(s). The Department does not

guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to

be connected to the facilities of the local telecommunications company. The

equipment must also be installed using an acceptable method of connection.

The customer should be aware that compliance with the above conditions

may not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative

designated by the supplier. Any repairs or alterations made by the user to

this equipment, or equipment malfunctions, may give the

telecommunications company cause to request the user to disconnect the

equipment.

Users should ensure for their own protection that the electrical ground

connections of the power utility, telephone lines and internal metallic water

pipe system, if present, are connected together. This precaution may be

particularly important in rural areas.

Caution: Users should not attempt to make such connections themselves,

but should contact the appropriate electric inspection authority, or

electrician, as appropriate.

2 The user manual of analog equipment must contain the equipment’s

Ringer Equivalence Number (REN) and an explanation notice similar

to the following:

The Ringer Equivalence Number (REN) of this device can be found on the

label affixed to your computer.

NOTICE: The Ringer Equivalence Number (REN) assigned to each

terminal device provides an indication of the maximum number of

terminals allowed to be connected to a telephone interface. The termination

on an interface may consist of any combination of devices subject only to

the requirement that the sum of the Ringer Equivalence Numbers of all the

devices does not exceed 5.

3 The standard connecting arrangement (telephone jack type) for this

equipment is jack type(s): USOC RJ11C.