Service Manual

– 138 –
A
B
A
B
Terminal block for remote controller
wiring of indoor unit
Terminal block
Remote controller
unit
Remote controller wire
(Procured locally)
A B
1
1
L N
2
2
3
3
220-2400V~
Remote controller
Remote controller wiring
Indoor side
Indoor/
Outdoor connecting wires
Outdoor side
13-3. Remote Controller Wiring
• Strip off approx. 9 mm the wire to be connected.
• For single system, use non polarity, 2 core wire is used for wiring of the remote controller.
(0.5 mm² to 2.0 mm² wires)
• For the synchronous twin, triple system, use 2-core shield wire (Vinyl cord for microphone 0.5 to 2.0 mm²) to
conform to the EMC standard.
Wiring diagram
∗ For details of wiring/installation of the remote controller, refer to the Installation Manual enclosed with the
remote controller.
<Single system>