User Guide
– 78 –
1 Push
SET
+
CL
+
TES
T
buttons simultaneously
for 4 seconds or more.
2 (
←←
←←
← Line address)
Using the temperature setup
/ buttons,
set
1212
1212
12
to the CODE No.
3 Using timer time / buttons, set the line address.
4 Push
SET
button. (OK when display goes on.)
5 (
←←
←←
← Indoor unit address)
Using the temperature setup
/ buttons, set
1313
1313
13
to the CODE No.
6 Using timer time / buttons, set 1 to the line address.
7 Push
SET
button. (OK when display goes on.)
8 (
←←
←←
← Group address)
Using the temperature setup
/ buttons, set
1414
1414
14
to the CODE No.
9 Using timer time / buttons, set
00000000
00000000
0000
to Individual,
00010001
00010001
0001
to Master unit, and
00020002
00020002
0002
to sub unit.
10 Push
SET
button. (OK when display goes on.)
11 Push
TES
T
button.
Setup completes. (The status returns to the usual stop status.)
10-5. Confirmation of Indoor Unit No. Position
1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1 Push
ON / OFF
button if the unit stops.
2 Push
U
NIT L
OU
VE
R
button.
Unit No.
1-11-1
1-11-1
1-1
is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
U
NIT L
OU
VE
R
button.