User Guide

3.32 SETUP 3 Tests and Diagnostics
QOSMIO F30 Maintenance Manual (960-555) [CONFIDENTIAL] 3-103
NOTE: 1. Do not remove the AC adaptor and battery pack at the same time when you
use this feature. If you do so, data saved by the resume function will be lost.
You must also reset this option.
2. If you have set a password and the computer boots by the Auto Power On
function and Standby is on, the computer will start with the instant security
function enabled. The password = message is not displayed; however, you
must enter the password to use the computer.
3. This option is enabled only once, the setting is reset, after booting up.
(f) Diagnostic Mode
This option enables/disables the HW Diagnostic test function.
Disabled Disables the HW Diagnostic test function. (Default)
Enabled Enables the HW Diagnostic test function.
8. Configuration
This option lets you set the device configuration.
All Devices BIOS sets all devices.
Setup by OS Initializes devices, which is needed to load an operating
system. Operating system initializes other devices.
(Default)
NOTE: 1. When using installed OS, selecting “Setup by OS” is recommended.
2. When executing test programs, be sure to select “ALL Device”. And after
the test end, select “Setup by OS”.