Owner's Manual

2. SYSTEM MODE EO13-33002
2.8 BASIC Setting
2-71
2.8.1 Basic Specification Selection Mode
This parameter is to choose whether to enable the BASIC specification function or not.
When “<8>BASIC” appears, press the [PAUSE] key.
2.8.2 Basic File Browser
This parameter is to display the data files in the program file and basic file area. Using this function allows
you to check the file names installed in the block.
2.8.3 Basic Trace Selection Mode
This parameter is to choose whether to enable the Basic trace function or not.
Usually, this function is set to OFF. When this function is enabled, it will be easier to find an erroneous
program as the program line number are displayed. However, the processing speed of BASIC interpreter
will be slower.
00 TEST.BAS
01 TEST.DAT
00 TEST.BAS
FILE MAINTENANCE
Program file is displayed.
[RESTART]
[PAUSE]
[RESTART]
Data file is displayed.
Data files in the BASIC file area are displayed each time the
[RESTART] key is pressed.
[PAUSE]
BASIC TRACE
Program file is displayed.
Basic file browser is completed by pressing the [PAUSE] key.
BASIC ENABLE
[PAUSE]
BASIC OFF
BASIC ON
FILE MAINTENANCE
[PAUSE]
[RESTART] or [FEED]
BASIC TRACE
TRACE OFF
[PAUSE]
TRACE ON
EXPAND MODE
[PAUSE]
Trace specification selection is completed by pressing
the [PAUSE] key.
[RESTART] or [FEED]