Owner's Manual

2. PRINTER SETUP ENGLISH VERSION EO1-33089

2.3 Loading Supplies

E2- 7

2.3.1 Loading the Media

(Cont.)

10. Lower the Print Head Block until it stops.

11. After loading the media, it may be necessary to set the Media

Sensors used to detect the print start position for label or tag printing.

Setting the Feed Gap Sensor position

(1) Manually move the Media Sensor so that the Feed Gap Sensor is

positioned at the centre of the labels. (z indicates the position of the

Feed Gap Sensor).

Setting the Black Mark Sensor position

(1) Pull about 500 mm of media out of the front of the printer, turn the

media back on itself and feed it under the Print Head past the sensor

so that the black mark can be seen from above.

(2) Manually move the Media Sensor so that the Black Mark Sensor is

in line with the centre of the black mark on the media. ( indicates

the position of the Black Mark Sensor).

NOTE:

e sure to set the black mark

sensor to detect the centre of the

black mark, otherwise a paper

am or no paper error may occur.

Label Media Sensor

Feed Gap Sensor (z)

Gap

Media

Media Sensor

Black Mark Sensor ()

Black Mark