Owner's Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
4.1DISC CUTTER (B-EX204-QM-R)
4- 3
4) Put the cutter in front of the printer. Connect one side of the cutter harness to CN15 on the Main PC
Board. And connect another side to the disc cutter PC Board.
5) Put the cutter on the printer through fit the hooks. And fix it to the printer with the two M4x6 screws.
6) Fit the cutter cover on the cutter attachment screws, and fix it to the cutter unit with the two cutter
screws.
7) Reassemble the side panel (L) and close the top cover. Finally check the cutter operation.
CN15
Main PC Board
Cutter Harness
CN15 Disc cutter PC Board
Cutter Harness
Hooks
M3x6 screws
Screw