Owner's Manual
5. SYSTEM MODE EO18-33027
5.11 RFID Module Setting
5-77
5.11.2.4 RF channel / RF CHANNEL
It sets channel value of RFID write.
When the channel is set from 2CH to 8CH, the selected channel is used as fix.
When “AUTO” is selected, printer search available channel and set radio frequency to searched
channel. The order of searched channel is below.
(2 -> 8 -> 6 -> 4 -> 3 -> 7 -> 5 -> 2)
This setting is applicable for all models. But this setting is most effective to B-SX704-RFID-U2-R(UHF
for Japan) only.
・ AUTO
・ 2CH
・ 3CH
・ 4CH
・ 5CH
・ 6CH
・ 7CH
・ 8CH
5.11.3 Retry / RETRY
The following information related retry setting is displayed.
・ Position adjustment for re-issue / ADJ RETRY POSITION
・ Retry number for re-issue / ISSUE RETRY LABELS
・ Read retry / READ RETRY
・ Write retry / WRITE RETRY
5.11.3.1 Position adjustment for re-issue / ADJ RETRY POSITION
When RFID write error occur, printer feed and reverse tag by this setting distance and retry then retry
EFID write. When “0 is set, retry is not performed.
The setting between -3mm and +3mm is ignored.
Max. Min. Step Display Sign Integer
digit
Decimal
point
digit
0 fullfil Unit
99 -99 1 Decimal Non 2 0 Non mm