Troubleshooting

e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE© June 2005 TOSHIBA TEC
2 - 28
[5]
ALCF end fence home position sensorFence home posi-
tion
Other than home
position
BLCF end fence stop position sensorFence stop positionOther than stop
position
CEmpty sensor at LCF standby sideNo paperPaper present
DLCF side cover open/close switchCover closedCover opened
ELCF motor rotation status (Motor is rotating at
output mode (03))
Abnormal rotationNormal rotation
FLCF tray-up sensorTray at upper limit
position
Other than upper
limit position
GLCF feed sensorNo paperPaper present
HEmpty sensor at LCF feed sideNo paperPaper present
[6]
ALower drawer detection switchDrawer not installedDrawer present
BUpper drawer detection switchDrawer not installedDrawer present
CLower drawer paper stock sensorPaper almost emptyPaper present
DUpper drawer paper stock sensorPaper almost emptyPaper present
ELower drawer empty sensorNo paperPaper present
FUpper drawer empty sensorNo paperPaper present
GLower drawer tray-up sensorTray at upper limit
position
Other than upper
limit position
HUpper drawer tray-up sensorTray at upper limit
position
Other than upper
limit position
[7]
A---
B---
C---
D---
ESide cover open/close switchCover openedCover closed
FFront cover opening/closing switchCover openedCover closed
G---
HExit sensorPaper presentNo paper
[8]
ABypass feed paper width sensor 3
(Refer to table1)
Bit 1Bit 0
BBypass feed paper width sensor 2
(Refer to table1)
Bit 1Bit 0
CBypass feed paper width sensor 1
(Refer to table1)
Bit 1Bit 0
DBypass feed paper width sensor 0
(Refer to table1)
Bit 1Bit 0
EBypass sensorNo paperPaper present
FADU opening/closing switchADU openedADU closed
GADU exit sensorPaper presentNo paper
HADU entrance sensorPaper presentNo paper
Digital
key
ButtonItems to check
Contents
Highlighted display
e.g.
Normal display
e.g.