User manual

3
1600XP Series Installation and Operation Manual
2. Equipment Warning Labels
The following pages show examples of warning labels that may be attached to either the interior or ex-
terior of the UPS. Do not remove or cover any of the labels. If the labels are damaged or if additional
labels are required, contact your equipment representative for additional labels.
These labels are placed to provide useful information or to indicate an imminently hazardous situation
that may result in severe equipment/property damage, serious injury, or loss of life if instructions are
not followed.
P/N 63094 – External warning sign.
• Unit contains potentially dangerous voltages.
• Read the instruction manual before operating.
• There are no user serviceable parts inside.
Refer service to qualied personnel.
• Do not open the cover while power is applied,
or within ve minutes after removal of power.
• Potentially hazardous leakage current may
exist. Ensure the grounding is connected
before connecting the utility power.
P/N 48518 – Battery terminals can deliver
dangerous electrical shock. Service by
qualied service representatives only.
WARNING
This unit contai ns se ale d lead acid batterie s.
La ck of p reventa tive m ainte nan ce cou ld result
in b atte ries e xplod in g a nd e mittin g ga sses an d/o r
flam e. An nu al preven tative main tena nce must be
pe rfo rm ed by a n a utho rized , traine d te chnician .
WARNING
CR IT ICAL F USE SIZ ING
Incorrect fu se replacem ent size
may result in fire or inadeq uate
equ ipm ent protection.
Re pla ce only with same t ype
and rating of fuse.
49455 SHEET
CAUTIO N/
A TTEN TI O N
Do not di sco nnect
whi le uni t is
o pe rating
on battery power.
Nes pas debrancher
sou s cha rg e.
48524 SHEET
Risk of electric shock. Do not re move cover.
. Refer servicing to qualified service personnel.
N O USER SERV IC EAB LE PA RTS
INSIDE
To reduce the risk of fire or electric shock, install in a temperature and
hum id ity controlled indoor area free of conduc tive contaminants.
En c as utilisa tion en atm osphere controlee. Consulter la notice technique.
Note: Service personnel only.
Haza rdous live parts inside the UPS are energized from the ba ttery supply
even when the input AC power is disconnected.
Capac itors store hazardous energ y. Do not rem ove cover until 5 minutes
after disconnecting all sources of supp ly.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually b etween service period s. The batteries should be
replaced every three yea rs after the last servicing, the date of which is
written on the ID plate lo cated on the rea r side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do no t i n sert ba tte ry trays with the p ower off !
Th is uni t is desi gned for ho t chan geable batteries!
When installi ng batteries, the UPS must be in th e
on lin e o r b ypass mode. Contact Tosh iba
In tern ati onal Co rporation fo r further details.
6041 2
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do n ot touch u ninsulat ed
batt ery terminals. Batteries sh ould be serviced b y
qua lified service repre se ntative only. Miswiring of
batt ery could result in ele ctrcal shock a nd/or fire.
Risque de choc electrique . Le circuit des ba tteries
nest pa s e so led e secteur. Les cosses des ba tteries
peu vent pr ese nter une te nsion dange reu se part
rapport a la terre. Ve rifier avan t de touch er.
DANGER
Batte ry fuse is always
l iv e. R isk of e le ct r i ca l
shock. Check fuse
voltage an d discon nect
external batte ries
befo re cha nging fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AND DOMESTIC COMPONENTS HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 6038 1
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO 1
EPO 2
RE M O TE
REMOTE
1
L1
L2 G
X1 X2
208V
120V
120V
20 8/ 2 40 V
O UTPUT
I N PUT
N
X3
G
208V
USE COPPER 90 C ONDUC TORS ON LY. REFER TO IN STRUCTION MANUAL REGARDING TIGHTENING TORQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 2 08V INPUT.
C OM
2
3
4
5
6 7
8
11
12
13
240V
240V
RE M O TE
JUMPE R SEL ECTION
50802
P/N 49455 – UPS Batteries require an-
nual preventative maintenance. Failure to
perform regular maintenance could result in
batteries exploding, or emitting gasses or
ame.
WARNING
This unit contains se ale d lead a cid batt erie s.
La ck of p re venta tive m ainte nan ce cou ld result
in b atte ries e xplod in g a nd e mittin g ga sses an d/o r
flam e. An nu al preven tative main tena nce must be
pe rfo rm ed by a n a utho rized , traine d te chnician .
WARNING
CR IT ICAL F USE SIZ ING
Incor rect fu se replacem ent size
may result in fire or inadeq uate
equ ipm ent protection.
Re pla ce only with same t ype
and rating of fuse.
49455 SHEET
CAUTIO N/
A TTEN TI O N
Do not disco nne ct
whi le uni t is
o pe rating
on battery power.
Nes pas debrancher
sou s cha rg e.
48524 SHEET
Risk of electric sho ck. Do not re move cover.
. Refer servicing to qualified se rvice personnel.
N O USER SERVIC EABLE PARTS
INSIDE
To reduce the risk of fire or electric shock, install in a te mperature and
hum idity controlled indoor area free of conduc tive contaminants.
En c as utilisation en atm osphe re controlee. Consulter la notice technique.
Note: Service pe rsonnel only.
Hazard ous live p arts inside the UPS are energized from the ba ttery supp ly
even when the input AC power is d isconnected.
Capac itors store hazardous energ y. Do not rem ove cover until 5 minutes
after d isconnecting all sources of supply.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually between service periods. The batteries should be
replaced every three years after the last servicing, the da te of which is
written on the ID plate lo cated on the rea r side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do no t i nsert ba tte ry trays w ith the power off !
Th is uni t is desi gned for ho t chan geable bat teries!
When i nstalling batteries, the UPS must b e in the
on lin e or bypass mo de. Contact Toshiba
In ternational Corporatio n for further details.
6041 2
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do n ot touch u nin sulat ed
batt ery terminals. Batteries should be serviced b y
qua lified service represe ntative only. Miswiring of
batt ery could result in electrcal shock and/or fire.
Risque de choc electrique . Le circuit des ba tteries
nest pa s e solede secteur. Les cosses des ba tteries
peu ven t presenter une te nsion dangereu se part
rapport a la terre . Ve rifier avan t de to ucher.
DANGER
Batte ry fuse is always
l iv e. R isk of e le ctr ica l
shock. Check fuse
voltage an d discon nect
exter nal batte ries
befo re cha nging fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AN D DOMESTIC COMPONENTS HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 6038 1
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO 1
EPO 2
RE M O TE
REMOTE
1
L1
L2 G
X1 X2
208V
120V
120V
20 8/ 2 40 V
O UTPUT
I N PUT
N
X3
G
208V
USE COPPER 90 C ONDUCTORS ON LY. REFER TO IN STRUCTION MANUAL REGARDING TIGHTENING TO RQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 2 08V IN PUT.
C OM
2
3
4
5
6 7
8
11
12
13
240V
240V
RE M O TE
JUMPER SELECTION
50802
P/N 49455 – Replace Fuse only
with one of same type and range.
Incorrect fuse size may result in
equipment damage.
WARNING
This unit contai ns se ale d lead acid batterie s.
La ck of p reventa tive m ainte nan ce cou ld result
in b atte ries e xplod in g a nd e mittin g ga sses an d/o r
flam e. An nu al preven tative main tena nce must be
pe rfo rm ed by a n a utho rized , traine d te chnician .
WARNING
CR IT ICAL F USE SIZ ING
Incorrect fu se replacem ent size
may result in fire or inadeq uate
equ ipm ent protection.
Re pla ce only with same t ype
and rating of fuse.
49455 SHEET
CAUTIO N/
A TTEN TI O N
Do not di sco nnect
whi le uni t is
o pe rating
on battery power.
Nes pas debrancher
sou s cha rg e.
48524 SHEET
Risk of electric shock. Do not re move cover.
. Refer servicing to qualified service personnel.
N O USER SERV IC EAB LE PA RTS
INSIDE
To reduce the risk of fire or electric shock, install in a temperature and
hum id ity controlled indoor area free of conduc tive contaminants.
En c as utilisa tion en atm osphere controlee. Consulter la notice technique.
Note: Service personnel only.
Haza rdous live parts inside the UPS are energized from the ba ttery supply
even when the input AC power is disconnected.
Capac itors store hazardous energ y. Do not rem ove cover until 5 minutes
after disconnecting all sources of supp ly.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually b etween service period s. The batteries should be
replaced every three yea rs after the last servicing, the date of which is
written on the ID plate lo cated on the rea r side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do no t i n sert ba tte ry trays with the p ower off !
Th is uni t is desi gned for ho t chan geable batteries!
When installi ng batteries, the UPS must be in th e
on lin e o r b ypass mode. Contact Tosh iba
In tern ati onal Co rporation fo r further details.
6041 2
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do n ot touch u ninsulat ed
batt ery terminals. Batteries sh ould be serviced b y
qua lified service repre se ntative only. Miswiring of
batt ery could result in ele ctrcal shock a nd/or fire.
Risque de choc electrique . Le circuit des ba tteries
nest pa s e so led e secteur. Les cosses des ba tteries
peu vent pr ese nter une te nsion dange reu se part
rapport a la terre. Ve rifier avan t de touch er.
DANGER
Batte ry fuse is always
l iv e. R isk of e le ct r i ca l
shock. Check fuse
voltage an d discon nect
external batte ries
befo re cha nging fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AND DOMESTIC COMPONENTS HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 6038 1
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO 1
EPO 2
RE M O TE
REMOTE
1
L1
L2 G
X1 X2
208V
120V
120V
20 8/ 2 40 V
O UTPUT
I N PUT
N
X3
G
208V
USE COPPER 90 C ONDUC TORS ON LY. REFER TO IN STRUCTION MANUAL REGARDING TIGHTENING TORQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 2 08V INPUT.
C OM
2
3
4
5
6 7
8
11
12
13
240V
240V
RE M O TE
JUMPE R SEL ECTION
50802