User guide
Table Of Contents
- TOSHIBA PORTÉGÉ S100 Portable Personal Computer - User’s Manual
- Table of Contents
- General Precautions
- Preface
- Chapter 1 - Introduction
- Chapter 2 - The Grand Tour
- Chapter 3 - Getting Started
- Chapter 4 - Operating Basics
- Using the Touch Pad
- Using the USB floppy disk drive (optional)
- Changing Ultra Slim Bay modules
- Using optical media drives
- Writing CDs on DVD-ROM&CD-R/RW drive
- Writing CD/DVDs on DVD Super Multi drive
- Media care
- Sound System
- Modem
- Wireless communications
- LAN
- Cleaning the computer
- Moving the computer
- Using the Hard Disk Drive (HDD) Protection
- Heat dispersal
- Chapter 5 - The Keyboard
- Chapter 6 - Power and Power-Up Modes
- Chapter 7 - HW Setup
- Chapter 8 - Optional Devices
- Chapter 9 - Troubleshooting
- Appendix A - Specifications
- Appendix B - Display Controller and Modes
- Appendix C - Wireless LAN
- Appendix D - TOSHIBA RAID
- Appendix E - AC Power Cord and Connectors
- Appendix F - If your computer is stolen
- Glossary
- Index
![](/manual/toshiba/portege-s100/user-guide-english/images/img-157.png)
User’s Manual 9-7
Troubleshooting
Real Time Clock
Password
Keyboard
Keyboard problems can be caused by your setup configuration. For more
information refer to Chapter 5, The Keyboard.
Problem Procedure
The following
message is Displayed
on the LCD screen:
RTC battery is
low or CMOS
checksum is
inconsistent.
Press [F1] key to
set Date/Time.
The battery for RTC is wearing. Set the date and
time in BIOS setup with the following steps:
1. Press F1 key. BIOS setup will boot up.
2. Set the date in System Date.
3. Set the time in System Time.
4. Press End key. Confirmation message will
appear.
5. Press Y key. BIOS setup will terminate and
the computer will be rebooted.
Problem Procedure
Cannot enter
password
Refer to the TOSHIBA Password Utility section in
Chapter 6, Power and Power-Up Modes.
Problem Procedure
Some letter keys
produce numbers
Check that the numeric keypad overlay is not
selected. Press Fn + F10 and try typing again.
Output to screen is
garbled
Make sure the software you are using is not
remapping the keyboard. Remapping involves
reassigning the meaning of each key. See your
software’s documentation.
If you are still unable to use the keyboard,
consult your dealer.