User's Manual

Getting Started

Adding memory (optional)

If no memory slot is available, you must remove a module by

performing steps 2-3 of “Removing a memory module” on page 58.

11 Pick up the memory module by its sides, avoiding any contact

with its connector. Position the module toward the socket,

aligning the connector’s notch with the matching key in the

socket.

(Sample Illustration) Aligning the memory module with the socket

12 Firmly press the memory module into the memory slot’s socket

at approximately a 30-degree angle (to the horizontal surface

of the computer).

(Sample Illustration) Inserting the memory module into the socket

NOTE

latch

key

notch

connector