- TOSHIBA Personal Computer M200 User's Manual

6-8
User's Manual
POWER AND
POWER-UP MODES
Caution
1. Never continue to use a Battery Pack after its recharging capacity has become
impaired, or after the display of a warning message indicating that the Battery
Pack's power is exhausted. Continued use of an exhausted or impaired Battery
Pack could cause the loss of data.
2. Never dispose of Battery Packs with normal trash. Bring them to your
TOSHIBA dealer or to another recycling center to save resources and prevent
environmental damage. Cover the terminals with electrical tape to prevent
short-circuits, which could cause the Battery Pack to ignite or rupture
3. Use only Battery Pack recommended by TOSHIBA as replacements.
4. Always make sure the Battery Pack is installed correctly and securely.
Otherwise, a Battery Pack could fall out and possibly cause injury.
5. Charge the Battery Pack only in an ambient temperature between 5 and 35
degrees Celsius. Otherwise, the electrolyte solution might leak, Battery Pack
performance might deteriorate and the battery life might be shortened.
6. Be sure to monitor the remaining battery power. If the Battery Pack and real
time clock battery discharge completely, Standby and Suspend will not
function and data in memory will be lost. Also, the computer might register an
incorrect time and date. In this case, connect the AC adaptor to recharge the
batteries
7. Never install or remove the Battery Pack without first turning off the power
and disconnecting the AC adaptor. Never remove the Battery Pack while the
computer is in Suspend of Standby mode. Data will be lost.
Note
1. Never remove the Battery Pack while the Wake-up on LAN function is
enabled. Data will be lost. Before you remove a Battery Pack, disable the
Wake-up on LAN function.
2. To ensure the Battery Pack maintains maximum capacity, operate the computer
on battery power once a week until the Battery Pack is fully discharged. Refer
to the section Extending battery life in this chapter for procedures. If the
computer is continuously operated on AC power for an extended period, more
than a week, the battery might fail to retain a charge. It might not function
efficiently over the expected life of the Battery Pack and the Battery indicator
might not indicate a low-battery condition.
3. After the Battery Pack is charged, avoid leaving the AC adaptor connected
and the computer turned off for more than a few hours at a time. Continuing to
charge a fully-charged Battery Pack can damage the battery.