TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA MK2008GAL (HDD1662) 1.
CONTENTS Introduction..............................................................................1 Setup ........................................................................................2 Using the HDD .........................................................................3 Specifications ..........................................................................4 Drive Connectors.....................................................................
INTRODUCTION – MK2008GAL (HDD1662) HARD DISK DRIVE General Features • 1.8" sized drive • 1 Platter • 20 Gigabytes* • 5mm High • 15ms Average Seek Time • ATA-6 Interface • Ultra DMA 100 • 2Mbytes Buffer • Rotational speed of 4,200rpm • MTTF 300,000 Hours *Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes.
SETUP – MK2008GAL (HDD1662) HARD DISK DRIVE Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive. Figure 1. MK2008GAL Side View Installation Notes • Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the specified area is 2N.
USING THE HARD DISK DRIVE – MK2008GAL (HDD1662) HARD DISK DRIVE Backing up Data Files To avoid data loss, regularly back up the data files on the hard disk drive.
SPECIFICATIONS – MK2008GAL (HDD1662) HARD DISK DRIVE General Model Interface MK2008GAL (HDD1662) ATA-6 Functionality Formatted Capacity Rotational Speed Avg. Rotational Latency Spin-up Time Buffer Seek Time Average Maximum Internal Transfer Rate Host Transfer Rate Ultra DMA mode PIO Mode Interleave Factor 20.0GB* 4200rpm 7.14/ms 3.5sec (typical) 2Mbytes 15 26 132.6 ~ 230.9 Mbits/sec (max) 100Mbytes/sec 16.
Physical Height Width Depth Weight 0.2" (5.0mm) 2.13" (54.0mm) 2.79" (71.0mm) 1.7oz (48g) typ Regulatory The drive satisfies the following standards: Underwriters Laboratories (UL) 1950 Canadian Standard Association (CSA) C22.2 No.
DRIVE CONNECTORS – MK2008GAL (HDD1662) HARD DISK DRIVE Figure 1.
Interface Signals DRIVE INTERFACE SIGNALS PIN SIGNAL PIN SIGNAL 1 RESERVED 2 RESERVED 3 - RESET 4 GROUND 5 DD 7 6 DD 8 7 DD 6 8 DD 9 9 DD 5 10 DD 10 11 DD 4 12 DD 11 13 DD 3 14 DD 12 15 DD 2 16 DD 13 17 DD 1 18 DD 14 19 DD 0 20 DD 15 21 GROUND 22 DMARQ 23 GROUND 24 -DIOW/STOP 25 - DIOR/ - HDMARDY HSTROBE 26 GROUND 27 IORDY/ - DMARDY/DSTROBE 28 GROUND 29 DMACK 30 INTRQ 31 DA1 32 - PDIAG/-CBLID 33 DA0 34 DA 2 35 - CS0 36 CS1 37 - DAS