Instruction Manual

Getting Started
Starting up the system
34
Starting up by the hard disk drive unit (in the case the OS has
been installed)
For starting up the server by the hard disk drive unit, proceed as
follows:
1
Make sure that neither the floppy disk nor CD-ROM that is
capable of starting up the server is in either drive unit.
2
Turn on the power/sleep button.
NOTE: The CD-ROM can be ejected from the CD-ROM drive
unit only when the system is turned on. Remove the CD-
ROM from the drive unit before turning off the system without
fail.
If you are in doubt as to whether CD-ROM is set in the CD-
ROM drive unit, check by pressing the eject button of the CD-
ROM drive unit. This procedure must be done while the
power-on self test is being performed after the power/sleep
button is turned on.
If the startup CD-ROM is placed in the CD-ROM drive unit,
the startup operation from the hard disk drive unit will result in
failure, even if the CD-ROM is ejected once the system is has
been switched on.