Owner's manual

258
Manually Configuring Clients for the Magnia SG30
Manually configuring clients using the Windows 95, 98 and
Windows Me operating system
5.375 x 8.375 ver 2.1
3 If Network Adapters does appear in the list of devices,
double-click the words Network Adapters.
If the computer is configured for networking through its
modem, the Dial-Up Adapter should be listed. If the
Dial-Up Adapter is the only network adapter installed on
the client computer, you must install a network adapter
card.
If any of the devices listed as a part of the Network
Adapters group has an exclamation point, that device
may not be physically working or may need to be
reconfigured. Click the device name and then click
Remove.
If any of the devices listed as a part of the Network
Adapters group has a red “X,” that device may be
disabled. Click the device name and then click
Properties. A new dialog box appears named
appropriately for your network adapter card. The
General page should contain a Device status message
that says, “The device is disabled.” If so, click the gray
box beside Original Configuration (Default) in the
Device Usage section of the dialog box.
If any other message appears, consult the documentation
supplied with the network adapter card and install the
card according to the manufacturer’s instructions.
4 If the System Properties dialog box is still displayed,
click OK to close the dialog box.