User's Manual

User’s Manual 8-7
Optional Devices
Removing the memory module cover
6. Lift one side of the insulator sheet and fit the module's connectors into
the computer's connectors at about a 45 degree angle. Press the
module carefully to ensure a firm connection.
7. Push the module down so it lies flat. Latches on either side will click into
place to secure the module.
Installing the memory module
8. Seat the cover and secure it with the screws.
9. Replace the battery pack as described in Chapter 6, Power and Power-
Up Modes.
10. Turn the power on and make sure the added memory is recognized.
Open System in the Control Panel and click the General tab.
Memory
Module
Cover
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
Slot A is reserved for main memory. Use slot B for expanded memory. If
only one card is installed use slot A.
Slot B
Slot A