User Manual and Operating Guide

G7 ASD Multi-Protocol Communication Option and PG Feedback Option Manual
29
Fault Code Fault Description Panel Display
0012 EEPROM write error EEP1
0013 EEPROM initial read error (control EEPROM) EEP2
0014 EEPROM initial read error (main circuit EEPROM) EEP3
0015 Main RAM error ERR2
0016 Main ROM error ERR3
0017 CPU error ERR4
0018 Communication interruption error ERR5
0019 Gate array error ERR6
001A Output current detect fault ERR7
001B Option board error ERR8
001C Flash memory error ERR9
001D Under-current fault UC
001E Under-voltage fault (main power) UP1
001F Under-voltage fault (control power) UP2
0020 Over-torque fault OT
0021 Earth fault (software detection) EF1
0022 Earth fault (hardware detection) EF2
0023 Fuse error EFU
0024 Dynamic braking resistor over-current fault OCR
0025 DC section over-current fault during acceleration OC1P
0026 DC section over-current fault during deceleration OC2P
0027 DC section over-current fault during constant-speed run OC3P
0028 Automatic tuning error ETN
0029 Drive type error ETYP
002A Sink / source selection error E-10
002B Electromagnetic brake error E-11
002C Encoder disconnected fault E-12
002D Speed error E-13
002E Positioning error E-14
0031 Key error E-17