User's Manual

34
PROBLEM SOLVING
a Set the Colour to Auto. and exit.
b Go to the Picture settings menu and adjust the tint.
Q
Why are there problems with text?
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the
main index page of the text service
and look for the
User Guide . This will explain the basic
operation of text in some detail. If further information
is needed on how to use text
see the text section .
Q
Why are there no text sub-pages?
A
There are none broadcast or they have not yet loaded.
Press the
l button to access.
(See text section) .
Q
Why are the four coloured text numbers visible but
no text?
A
Text has been selected whilst viewing an external
source i.e. DVD or VCR. No text will appear on screen
or a box may appear stating no information is
available. Select a broadcasting channel and press
TEXT to access.
Q
Why are the LEDs on the front of the television
flashing?
A
Check the table below.
LED indication
Condition Solution
LED-2 LED-1
OFF Green (Solid) The TV is operatin
properly.
–
OFF Red (Solid) Standby with Power-
On
–
Green
(Solid)
Red (Solid) On timer
–
OFF RED Blinks
0.5 sec cycle
Power protect
detection.
Turn OFF the TV and
unplug the power
cord. Plug the power
cord in again and turn
ON the TV.
OFF Red Blinks
1 sec cycle
Abnormal operation
of BUS line.
OFF 2 times
flashing with
2 sec interval
Abnormal operation
(Initialization error).
LED-2 LED-1
Q
Why are the colours wrong when an NTSC source is
played?
A
Connect the source via a SCART lead and play.
Select
Manual setting from the SET UP menu.
Q
Why don't the devices connected via HDMI operate
properly?
A
Make sure to use cables with the HDMI logo
(see page 9).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new standard
adoption. Try
Lip Sync setting to Off .
Q
Why don't the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed settings of the
device, turn off your television and unplug the power
cord, then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device and
lead again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A
If the REGZA-LINK is disconnected the logo will
disappear after approximately one minute.
EXT2 A V C R
OK
MENU EXIT
Manual setting
Colour system: Auto.
Store
Back Watch TV
00GB_CV500P_EngOM.book Page 34 Wednesday, March 5, 2008 1:15 PM