Owner Manual Projection Television 46H84, 46H84C, 51H84, 51H84C, 57H84, 57H84C, 65H84
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
39
(E) 46H84 51H84 57H84 65H84
Using the LOCKS menu
The LOCKS menu includes the V-Chip, CH Lock, Video Lock, and
New PIN Code functions. You can use these functions after entering
the correct PIN code.
Entering the PIN code
1. Press MENU, and then press x or • until the LOCKS menu
appears.
::ENDSELECT EXIT
V - CH I P
LOCKS
CH LOCK
V I DEO LOCK
OFF
NEW P I N CODE
2. Press y or z to display the PIN code entering mode.
123
456
7
89
ENT
100
0
POWER
RECALL
CHRTN
FAV
FAV
TV
/
VIDEO
+10
PIC SIZE
EXIT
INFO
STOP
POP DIRECT CH MUTE SLEEP
TV/VCR PAUSE
FFREW
SKIP
/
SEARCH
SPLIT
SWAP POP CH
LIGHT
REC
CH SCAN
FREEZE SOURCE
PLAY
TV
CBL/SAT
VCR
DVD
VOLCH
FAVORITE
ENTER
DVDMENU
MENU
T
O
P
M
E
N
U
G
U
I
D
E
C
L
E
A
R
E
N
T
E
R
yzx •
RECALL
Number
MENU
• Blocking Reset status:
Set your 4-digit code by pressing
the Number buttons (0–9).
• When the PIN code is already stored:
Press the Number buttons (0-9) to enter
the 4-digit PIN code used for blocking
channels.
SELECT: : SETENTER
0–9
BLOCK I NG RESET
LOCKS
P I N CODE
1110
BLOCK I NG ACT I VE
LOCKS
P I N CODE
1234
SELECT: : SETENTER
0–9
If the wrong PIN code is entered, the message “Incorrect”
appears. Enter the code again, and then press ENTER.
If you cannot remember your PIN code
1. While the PIN code entering screen is displayed, press RECALL
four times within five seconds. The PIN code will be released
(Blocking Reset status restored).
2. Set new 4-digit code, and then press ENTER.
The LOCKS menu appears.
V - CH I P
LOCKS
CH LOCK
V I DEO LOCK
NEW P I N CODE
: MOVE
OFF
: STARTENTER
Continue to set each item following the steps.
Using the V-CHIP menu
Some TV programs and movies include signals that classify the
content of the program (violence, sex, dialog, language). The V-CHIP
conrol feature in this TV detects the signals and blocks the programs
according to your selections. To use this feature, perform the
following setup.
ENTER
Note:
The V-Chip function is available only for the
U.S. V-Chip system. The Canadian V-Chip
system is not supported.
(continued on next page)