Laptop User Manual

User’s Manual C-6
Information for Wireless Devices
Taiwan
Using this equipment in Japan
In Japan, the frequency bandwidth of 2,400MHz to 2,483.5MHz for second
generation low-power data communication systems such as this equipment
overlaps that of mobile object identification systems (premises radio station
and specified low-power radio station).
1. Important notice
The frequency bandwidth of this equipment may operate within the same
range as industrial devices, scientific devices, medical devices, microwave
ovens, licensed radio stations and non-licensed specified low-power radio
stations for mobile object identification systems (RFID) used in factory
production lines (Other Radio Stations).
1. Before using this equipment, ensure that it does not interfere with any of
the equipment listed above.
2. If this equipment causes RF interference to other radio stations,
promptly change the frequency being used, change the location of use,
or turn off the source of emissions.
Contact an authorized TOSHIBA service provider if you have problems with
interference caused by this product to Other Radio Stations.
Article 12 Without permission granted by the NCC, any com-
pany, enterprise, or user is not allowed to change
frequency, enhance transmitting power or alter origi-
nal characteristic as well as performance to an
approved low power radiofrequency devices.
Article 14 The low power radio-frequency devices shall not
influence aircraft security and interfere legal commu-
nications;
If found, the user shall cease operating immediately
until no interference is achieved.
The said legal communications means radio com-
munications is operated in compliance with the Tele-
communications Act.
The low power radio-frequency devices must be
susceptible with the interference from legal commu-
nications or ISM radio wave radiated devices.