Printer User Manual

6-39
EM18-33010A
6. DIAG. TEST OPERATION
(Revision Date: Dec. 10 ‘99)
6.3 PARAMETER SETTING MODE
6.3.17 Transmission Control Mode Selection
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enable.
2. A changed Transmission Control Mode is memory by pressing the [PAUSE] key.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
Press the [PAUSE] key 19 times.
Select the Transmission Control
Mode with the [FEED] key
or [RESTART] key.
Press the [FEED] key and
[RESTART] key at the
same time.
• DTR: READY/BUSY (DTR) protocol
(DTR/DSR)
• RTS: READY/BUSY (RTS) protocol
(RTS/CTS)
< 1 DI AGN I C. V>
1. OA
OS T
<2 PARAM R SET>
ETE
DT /RTS R
DTR
Press the [PAUSE] key.
Continued on Section 6.3.18
Reset Selection when the
INPUT • PRIME Signal is ON.