User's Manual

33
CONTROLS AND FEATURES
English
If the connected HDMI source does not support digital audio,
plug the audio cable into
HDMI1 (AUDIO) on the back of the
television (as shown in the ‘Connecting an HDMI™ or DVI device
to the HDMI input’ section), then use the
HDMI1 Audio setting.
a In the AV Connection menu press u to highlight
HDMI1 Audio and using I or i select Auto or
Analogue .
If the sound is missing select an alternative setting.
NOTE: HDMI1 supports digital and analogue sound,
HDMI2 is digital sound only.
Certain DVD disk formats may not output from this TV
(32/44.1/48kHz and 16/20/24 bits are acceptable).
Lip Sync can synchronize the sound and picture. This feature is
only available for HDMI equipment compatible with Lip Sync.
NOTE: Disconnect the HDMI cable before changing the Lip
Sync
setting. If the HDMI cable is connected, a message will
appear.
a Select the appropriate HDMI input from the input
selection window.
b In the AV Connection menu press u to highlight Lip
Sync
.
c Using I or i select On or Off .
When connecting a surround sound amplifier to the digital
audio output (Sony/Philips Digital Interface Format
[S/PDIF]), the following options can be selected.
PCM: this mode outputs PCM format to the digital audio output
socket.
Auto: this mode outputs Dolby Digital or PCM to the digital
audio output socket providing it is being broadcast.
Dolby Digital S Dolby Digital
Dolby Digital Plus
S Dolby Digital
MPEG
S PCM
a In the AV Connection menu press u to select Digital
Output
.
b Use I or i to select PCM or Auto .
HDMI1 Audio
AV Connection
Lip Sync
HDMI1 Audio
EXT2 Input
Digital Output
PCM
Auto
Off
AV
Lip Sync Latency
Digital Output
HDMI, the HDMI logo, and High-Definition Multimedia Interface
are trademarks or registered trademarks of HDMI Licensing,
LLC.
00GB_AV565D_Euro.book Page 33 Tuesday, July 22, 2008 10:42 AM