User manual

e-STUDIO3511/4511 GENERAL OPERATION 4 - 2 November 2003 © TOSHIBA TEC

4.2.2 Ready (ready for copying)

• Buttons on the control panel enabled

• When no button is pressed for a certain period of time,

- Set number “1” and reproduction ratio “100%” are displayed. Equipment returns to the normal

ready state.

4.2.3 Drawer feed copying (Upper drawer paper feeding)

(1) Press the [START] button ON

• “READY” changes to “COPYING”

• Exposure lamp turned ON

• Scan motor turned ON → Carriages-1 and -2 move forward

• Main motor, transport motor, developer motor and exit motor turned ON

- Drum, fuser unit, developer unit and exit roller are driven

• Drum cleaner brush motor turned ON

(2) Drawer paper feeding

• Fans rotated in high speed and upper drawer feed clutch turned ON

- Pickup roller, feed roller, separation roller and transport roller start to rotate

• Paper reaches the upper drawer feed sensor

-Upper drawer feed sensor is turned ON

• Paper reaches the registration roller

- Registration sensor is turned ON and aligning is performed

• Upper drawer feed clutch is turned OFF after a certain period of time

(3) A certain period of time passed after the carriage operation

• Registration clutch is turned ON after a certain period of time → Paper is transported to the

transfer area

• Copy counter operates

(4) Completion of scanning

• Scan motor turned OFF

• Exposure lamp turned OFF

• Registration clutch turned OFF (after the trailing edge of the paper passed the registration roller)

• “READY (PRINTING)” is displayed

(5) Printing operation

1) Color printing operation

• Black developer lifting clutch, black developer bias (+150), transfer belt cleaner clutch, toner

recovery auger, drum cleaner brush, discharge LED and cleaning blade bias turned ON

• Transfer belt cleaner auger motor turned ON

- Transfer belt used toner auger is driven

• Main charger and 1st transfer bias turned ON

• Transfer belt marker detection