Operation Manual

28
PROBLEM SOLVING
a Set the Colour to Auto and exit.
b Go to the Picture settings menu and adjust the tint.
Q
Why are there problems with text?
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the
main index page of the text service
and look for the
User Guide . This will explain the basic
operation of text in some detail. If further information
is needed on how to use text
see the text section .
Q
Why are there no text sub-pages?
A
There are none broadcast or they have not yet loaded.
Press the
l button to access.
(See text section) .
Q
Why are the four coloured text numbers visible but
no text?
A
Text has been selected whilst viewing an external
source i.e. DVD or VCR. No text will appear on screen
or a box may appear stating no information is
available. Select a broadcasting channel and press
to access.
Q
Why is the LED on the front of the television
flashing?
A
Check the table below.
LED indication Condition Solution
Green (Solid) The TV is operating
properly.
–
Red (Solid) Standby with
Power-On
–
RED Blinks
0.5 sec cycle
Power protect
detection.
Turn OFF the TV and
unplug the power
cord. Plug the power
cord in again and
turn ON the TV.
Q
Why are the colours wrong when an NTSC source is
played?
A
Connect the source via a SCART lead and play.
Select Manual setting from the SET UP menu.
Q
Why don't the devices connected via HDMI operate
properly?
A
Make sure to use cables with the HDMI logo
(see page 8).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new standard
adoption.
EXT2 A V C R
OK
MENU EXIT
Manual setting
Colour system: Auto
Store
Back Watch TV
00GB_AV500P_EngOM.book Page 28 Tuesday, December 11, 2007 5:40 AM