Operation Manual
12
SETTING UP
Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions
.
If the RED LED is unlit check that the mains plug is connected
to the power supply and press the
!
(POWER) button on the
left side of the television to switch the television on. If the
picture does not appear press
1
on the remote control, it may
take a few moments.
To put the television into Standby press
1
on the remote
control. To view the television press
1
again. The picture may
take a few seconds to appear.
To set up the television you will now need to use the on-screen
menus. Press
M
on the remote control to see the menus.
The menu bar at the top of the screens will show six different
topics shown in symbols. As each symbol is selected by
pressing
C
or
c
on the remote control, its respective options
will appear below.
To use the options, press
B
and
b
on the remote control to
move up and down through them and
Q
,
C
or
c
to select the
required choice. Follow the on-screen instructions. The
functions of each menu are described in detail throughout the
manual.
To alter the volume press –
2
+.
To alter the programme position press
b
p
B
.
Press
MENU
and
I
,
i
,
U
or
u
to control the sound and picture
options.
Press
MENU
to finish.
An S-video cable provides better picture performance than a
composite video cable. If you connect an S-video cable to
EXT3
, be sure to disconnect the standard (composite) video
cable or the picture performance will be unacceptable.
To select the external input, press
o
until the appropriate
input source is selected as described on
page 27
.
Please always refer to the owner’s manual of the equipment to
be connected for full details.
Standby
RED LED – Standby
GREEN LED – Power on
GREEN LED – On timer
INPUT 3
(EXT3)
POWER switch
Input 3
(side) will take
priority over
EXT3 (back) if
both connections
are used at the
same time.
HDMI3
INPUT
Switching on
Using the remote control
Using the controls and connections
00GB_XV500P_EngOM.book Page 12 Friday, February 15, 2008 10:42 AM