Flat Panel Television User Manual

5 To save the new settings, highlight Doneand press
@. To revert to the factory defaults, highlight
Reset and press @.
Displaying TV status information
To display TV status information using
RECALL:
Press _ on the remote control.
The following inl\_rmation will display (if
applicable):
• Current input (ANT[CABLE,Video, etc.)
• If ANT/CABLE is the current input, either
"CABLE" (for cable TV) or "ANT" (for over-the-
air broadcasts).
• Channel number (if in ANT/CABLEmode)
• Channel label (if applicable)
• Digital signal strength indicator (bar graph in lower
right corner of box; for ATSC signal only)
• Stereo, Mono, or SAP audio stares (when HDMI
input mode, Dolby Digital or PCM)
• Video resolution
• Aspect ratio of incoming video signal (4:3 or 16:9)
• V-Chip rating stams
• Game Timer (if set)
To close the RECALL screen:
Press ! again.
To display TV status information using
INFO:
Press [_o on the remote control.
The following additional information will display for
off air digital channels (if applicable):
• Title
• Duration
• Detailed description
Note: The location of the banner can be moved
to the top or bottom of the screen by pressing
or while the RECALL or INFO display is
onscreen.
Understanding the last mode
memory feature
If power is lost while you are viewing the TV_the
Last Mode Memory feature automatically turns on
the TV when power is restored.
Note: If you will be away from the TV for an
extended period of time you should unplug the
power cord.
50