Owner's Manual LCD Color Television 26HL86, 32HL86, 37HL86

ManualsBrandsToshiba ManualsFlat Panel TV32HL86

HL86 (E/F) Web 213:276

Chapter 5: Setting up your TV

Selecting the menu language

You can choose from three different languages (English,

French and Spanish) for the on-screen display of menus and

messages.

To select the menu language:

1 Press Y and open the Set Up menu.

2 Press B or b to highlight Language.

3 Press C or c to display your desired language.

4 Press O to close the Set Up menu.

Programming channels into the

TV’s channel memory

When you press < or , on the remote control or TV control

panel, your TV will stop only on the channels you program into

the TV’s channel memory.

Follow the steps below to program channels into the TV’s

channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your

area and store them in its memory. After the channels are

programmed automatically, you can manually add or erase

individual channels in the channel memory.

Note:

• If the input signal type is set to CABLE for an antenna input,

the automatic channel programming process erases

channels that were previously programmed into the TV’s

memory.

• If the input signal type is set to TV, the automatic channel

programming process does NOT erase channels that were

previously programmed into the TV’s memory, but adds

newly found channels to the existing set of programmed

channels. To remove a channel from the memory, you must

manually delete it.

• To tune the TV to a channel not programmed in the channel

memory, you must use the Channel Number buttons on the

remote control.

• Programming channels for an antenna input configured for

CABLE will take substantially longer than for an antenna

input configured for TV. This is normal; however, once

channel programming is completed, you should not have to

repeat the programming process again unless your Cable

TV service lineup changes significantly.

To program channels automatically:

1 Press Y and open the Set Up menu.

2 Press B or b to highlight TV/CABLE.

3 Press C or c to select either TV (if you use an antenna) or

CABLE (if you use cable channels).

Channel Labeling

Add/Erase

Ch Program

TV/CABLE

Language

Set Up

Back Watch TV

EXIT

English

Add

Video Label

ENTER

1/2