Flat Panel Television User Manual

22
Image tilt correction
When you install or change the direction of the TV, the picture may
become tilted (caused by the Earth’s magnetism.) If this happens, use
the image tilt correction feature to obtain the best possible picture.
To adjust the image tilt:
1. Press MENU, then press
or
until the SETUP menu appears.
2. Press ▲ or ▼ to highlight IMAGE
TILT.
3. Press or to adjust the picture
tilt (from –10 to +10.)
Adding channels to the TV’s memory
When you press CH 3 or 4, your TV will stop only on the channels you
have stored in the TV's channel memory. Follow the steps below to
program channels into the channel memory.
Programming channels automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory auto-
matically, you can add or erase channels manually.
To add channels automatically:
1. Press MENU, then press
or to display the SETUP menu.
2. Press ▲ or ▼ until the TV/CABLE
selection is highlighted.
3. Press or to highlight either
TV or CABLE, depending on
which you use.
If you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press ▼ until the CH PROGRAM selection is highlighted.
5.
Press or to start channel programming. The TV will automatically
cycle through all the TV or Cable channels (depending on which you
selected), and store all active channels in the channel memory.
While the TV is cycling through the channels, the message
“PROGRAMMING NOW-PLEASE WAIT” appears.
6. When channel programming is complete, the message “COMPLETED”
appears.
7. Press CH 3 or 4 to view the programmed channels.
Adding and erasing channels manually
After you have programmed the channels automatically, you can add
or erase specific channels manually.
To add or erase channels manually:
1. Select the channel you want to add or erase. If you are adding a
channel, you must select the channel
using the Channel Number buttons.
2. Press MENU, then press
or to
display the SETUP menu.
3. Press ▲ or ▼ to highlight ADD/
ERASE.
4. Press
or to select ADD or
ERASE, whichever function you want to perform.
5. Repeat steps 1-4 for other channels you want to add or erase.
Menu
Channel 34
SETUP
LANGUAGE
CLOCK SET
TV / CABLE
CH PROGRAM
ADD / ERASE
ENGLISH
12:00AM
CABLE
ADD / ERASE
:SELECT :ADJUST
SETUP
CLOSED CAPTION
PICTURE SIZE
PICTURE SCROLL
CINEMA MODE
ASPECT
IMAGE TILT
:SELECT :ADJUST
OFF
VIDEO
ON
0
Setting up
your TV
J3S40121A(E)_P16-23 18/01/2005, 9:50 AM22