Flat Panel Television User Manual

50
Chapter 6: Using the TV’s features
Clock
Phase
Helps to reduce noise and sharpen the
picture.
The adjustment range is within ±16 from
center.*
Sampling
Clock
Helps to reduce noise and minimize
periodic vertical stripes on the screen.
The adjustment range is within ±10 from
center.*
Auto
Adjust
Highlight this item then press
to get an optimum adjustment
automatically.
*
The default settings may vary depending on
the input signal format.
Setting the PC Audio
This function allows you to output or mute the sound
from your PC when connecting using the PC IN
terminal and an analog RGB cable. ( page 19)
To set the PC Audio:
1無
Press and open the Audio menu.
2無
Highlight Audio Setup and press .
3無
Press p or q to select PC Audio and then press
t or u to select No or Yes.
Yes: When viewing the PC input, the audio from
the PC Audio input can be heard.
No: When viewing the PC input, there will be no
audio.
Note: Because the PC and HDMI-1 inputs
share the same set of analog audio inputs,
the PC Audio menu setting influences the
HDMI 1 Audio menu setting. If PC Audio
is set to “No,” the HDMI 1 Audio setting
changes to “Auto.” If PC Audio is set to
“Yes,” the HDMI 1 Audio setting is set to
“Digital” and is grayed out in the menu.
(Also see item 7 on page 12 and “Setting the
HDMI™ Audio mode” on page 32.)
Setting the sleep timer
You can set the sleep timer to turn off the TV after a
set length of time (maximum of 180 minutes).
To set the sleep timer using the remote control:
Press on the remote control to set the length of
time until the TV turns off. Repeatedly press
to increase the time in 10-minute increments, or
press p or q to increase or decrease the time in
10-minute increments, to a maximum of 180 minutes.
To set the sleep timer using the on-screen
menus:
1無
Press and open the Setup menu.
2無
Highlight Sleep Timer and press .
3無
Press the Number buttons to enter the length of
time in 10-minute increments.
4無
Highlight Done and press .
Note: When a power failure occurs, the
sleep timer setting may be cleared.
To display the remaining sleep time:
Press .
Note: A message will display on-screen when
there is one minute remaining on the sleep timer.
To cancel the sleep timer:
Repeatedly press until it is set to 0 minute.
Using REGZA-LINK
®
This is a new feature that uses CEC technology
and allows you to control Toshiba REGZA-LINK
compatible devices from the TV remote via HDMI
connection ( page 17).
When the Enable REGZA-LINK in the REGZA-
LINK setup menu ( page 51) is set to On, the
following REGZA-LINK functions will be enabled.
REGZA-LINK
®
playback device (DVD
player, etc.) control
With your TV’s remote control, or using the REGZA-
LINK Player Control menu, you can control the
connected REGZA-LINK playback device you are
watching.
Available remote control key functions:
Before using the following key functions, first set the
MODE SELECT switch on the remote control to TV.
Button Description
Begins playback.
Stops playback.
Pauses the picture during play or record
mode.
Skips forward.
Skips backward.
Fast-forwards.