Service Manual

IGNITION 2-2
6. Remove flywheel with a flywheel puller (A).
7. Remove and inspect flywheel key. Replace the
key if
it is bent or sheared.
8. Inspect crankshaft taper for nicks or burrs.
If necessary, finish taper using fine emery
paper.
FLYWHEEL CHECK
CAUTION: Do not give impact to magnet, as
impact weakens magnetic force of it.
1. Put flywheel on a wooden surface.
2. Hold a metal tool about 25mm (1 in.) away
from flywheel magnet. The metal tool should
be attracted by magnet. If magnetic force
is weak, replace flywheel.
CAUTION: Do not cut flywheel by drilling too
deep or too close.
(2) By using a hammer and bar, strike ring gear
evenly to remove
it.
drill 5/16 deep (4-6) drill holes gear
(3) Heat a new ring gear (C), evenly to an extent
that expansion by heating facilitates following
installation.
(4) With the beveled edge of the gear faced up,
quickly install ring gear, quickly followed
by
tapping ring gear evenly to insure good seating.
New ring gear