Installation Instructions

Installation Instructions
5
Installing New Collection Bin
Back Plate
The new plates will increase support for the latches.
1. Unlatch and open rear lid on grass collection bin.
2. Remove existing bolts, washers and latch
(Fig. 7).
Note: It may be necessary to remove the bin
flange in order to get proper access to
bolts and washers (Fig. 7).
3. Discard the washers and replace with back plate.
Tighten bolts, back plate and latch (Fig. 7).
4. Repeat for latch on other side of collection bin.
M-4238
8 2 5
4
3
5 6 7
1
Figure 7
1. Bolt
2. Back
Plate
3. Latch
4.
Hex Head Screw
5. Spacer
6.
Bin Flange
7. Nut
8. W
asher (Discard)
Installing New W asher on
Collection Bin Pegs
The new washers will increase support for the latch
pegs.
1. Unlatch and open rear lid on grass collection bin.
2. Remove existing bolt, washer and latch peg
(Fig. 8).
3.
Replace existing washer with new washer .
Tighten bolt, washer and latch peg (Fig. 8).
4. Repeat for other two latch pegs on collection bin
(Fig. 8).
M-4239
1
2
3
1 2 3
Figure 8
1. Latch Peg
2. W asher (.216x.750)
3. Screw