Installation Instructions

2
Install Oil Hoses
1. Thread 1/2” NPTF fittings into filter adapter.
2. Torque fittings to 90–130 in. lbs. (10–15 N•m)
ending between 12 and 3 o’clock as shown
(Fig. 2).
3. Thread fixed hose ends into 1/2” NPTF fitting
(Fig. 2).
m–3973
4
2
5
1
3
Figure 2
1. Filter adapter
2. 1/2” NPTF fitting
3. Between 12-3 o’clock
4. Oil hose, fixed end
5. OUT port
Install Remote Filter Adapter
1. Measure back 6-1/2” (165 mm) from left frame
upright to front of plate. Center filter plate holes
on flange width and clamp plate in position
(Fig. 3).
2. Using filter plate as a guide, drill (2) 11/32”
(9 mm) mounting holes through bottom flange
of left side engine frame (Fig. 3).
3. Secure filter plate to bottom flange of engine
frame with (2) 5/16-18 x 1” (26 mm) bolts and
(2) 5/16-18 flange locknuts (Fig. 3).
m–3981
3
2
1
4
Figure 3
1. 6-1/2” (165 mm)
2. Drill (2) 11/32’ (9 mm)
holes in left side engine
frame
3. Bolt 5/16-18 x 1” (26 mm)
4. flange locknut 5/16-18