Service Manual

TORO®- Grandstand Service Instruction Manual 3-3
CHASIS
3
Parking Brake Installation (Figure 3)
1. Attach the bail switch to the brake handle assembly
2. Lift brake handle assembly through the hole in the
tower.
3. Place foam grip on the brake handle assembly.
4. Secure brake handle assembly with 3 nuts and
bolts.
5. Hook the cable spring to the brake handle assembly.
6. Run cables through the cable clamp (do not tighten
at this time).
7. Place both cable ends into the brake calipers.
8. Route calipers to the frame, ensure cables do not
interfere with IHT fans, pulleys or IHT belt.
9. Drop the brake caliper arm into the hole of IHT
parking brake arm (Figure 5).
10. Use screw to attach brake caliper to horizontal bar
on frame
11. Align brake caliper with hole in the frame and
secure with flange nut (Figure 6). Torque to 125
+/- 20 in. lbs
12. Pull downward on both cables and tighten the
cable clamp. Torque to125 +/- 20 in. lbs.
Figure 5
Figure 6