Operator's Manual

5
DESCRIPTION USEQTY.
Bolt 3/8 x 1-1/2 inch
Spacer.62 O.D x .60 Thk.
Washer 3/8 inch
Lock nut 3/8 inch
Spring catch
Lift assist spring
Eye bolt
Lock nut 3/8 inch
Belt
Belt
1
1
1
1
1
1
1
1
1
1
Installing the tiller to the tractor
Operator’s Manual 1 Read before installing and operating tiller.
Important A Front Pulley Box/PTO belt and Rear
Attach–A–Matic are required to install and operate the
tiller. If these kits are not already on the tractor, install
them per the instructions included with the kits.
If you do have these kits, they can be obtained from your
Authorized Service Dealer.
Installing the Tiller Hitch
1. Tip the tiller onto its back and support it in an upright
position. Remove the 3/8 x 5-1/2 inch and 3/8 x 4-1/2
inch bolts and the 3/8 inch nuts securing the gear case
together (Fig. 2). Discard extra nuts used as spacers for
shipping.
2
3
1
Figure 2
1. Gear case
2. Bolt, 3/8 x 5–1/2 inch
3. Bolt, 3/8 x 4–1/2 inch
2. Loosely mount the rear of the hitch and the spring
bracket to the rear of the gear case with the previously
removed 3/8 x 5-1/2 inch bolt and nut. Position
components as shown in figure 3. Tighten the bolts
securely.
Note: Make sure the bolt is positioned as shown in
figure 3.
2
1
3
Figure 3
1. Hitch
2. Spring bracket
3. Bolt, 3/8 x 5–1/2 inch